Material Safety Data Sheet – AQL - 300TM
Company : AQUALINE (A div of KCH India Pvt Ltd)
Address  :

C-17, Ambattur Industrial Estate

 Ambattur Chennai – 600 058                         
 Tamil Nadu, South India

Tel No : 044-26256071 / 7499
Fax No : 044-42060489
Date of Issue : May 2009


Product Name : AQL - 300
Chemical Family :


Hazardous material : Sodium Hexametaphosphate, Sodium polyacrylate.
Non-Hazardous material : Protected under NJ trade


Acute – Swallowed (Short term exposure):
Skin contact: Causes irritation seen as redness and itching.  Eye contact: Cause irritation seen as tearing and redness. Inhalation: Causes respiratory irritation seen as coughing, sneezing and nausea.  Ingestion: Causes irritation with possible nausea, vomiting and diarrhea.

Chronic (Long term exposure) :
No human chronic effects known.  Medical conditions aggravated by exposure are pre-existing respiratory and skin conditions such as asthma. Emphysema and dermatitis. Target organs:  None known.  There is no primary route of entry into the body.  The primary route of exposure is skin and eye contact

First Aid
Remove from the area to fresh air.  Seek medical attention if respiratory irritation develops or if breathing becomes difficult..
Immediately rinse the eyes with water. Remove any contact lenses and continue flushing for at least 15 minutes.  Hold the eyelids apart to ensure. Rinsing of the entire surface of the eyes and lids with water.
Get medical attention if irritation persists.
Wash affected area with large amounts of soap and water for 15 minutes.  Remove contaminated clothing and shoes.  Get medical attention if irritation persists.  Wash clothing and clean shoes before reuse.


Give 3 to 4 glasses of water, but do not induce vomiting.  If vomiting occurs, give fluids again.  Seek medical attention if discomfort occurs.

Notes to Physician
It’s no specific antidote.  Treat the patient symptomatically.


Do not induce vomiting.  Give large quantities of water.  Seek medical help.


Appearance : Transparent Water White Non-viscous liquid
Odor :

Slightly sweet.                         

Boiling Point : 212 degrees Fahrenheit
Vapor pressure : 17.5 mm Hg
Specific Gravity   : 1.16 at 25 degree Celsius
Viscosity : Non-Viscous
Flammability : Non-Flammable
Solubility in water : Complete
pH @ 100% : 7.0-8.0
Vapor density (Air: 1) : 0.6
Volatile by Volume : 77
Evaporation rate : 0.1



Conditions to Avoid : None known.
Incompatibility : Oxidizing agents such as Chlorine bleach and concentrated Hydrogen peroxide. Acids and bases.
Hazardous decomposition products : Oxides of Sodium, Phosphorous, carbon and Hydrocarbon residues.
Hazardous Polymerization : May occur.

Steps to be taken if released / spilled:
Dike and contain spill.
Absorb with an inert material and transfer all material into a properly labeled container for disposal.
Wear appropriate protective clothing. 

Waste disposal method:
Dispose of in accordance with all local, state, and federal regulations.

Neutralizing Agents:

 Local Ventilation is recommended to control exposure from operations that can generate mists.
A NIOSH/MSHA approved respirator is poorly ventilated areas and / or for exposure above the
ACGIH TLV OR OSHA PER or where misting exists.
Neoprene rubber of nitrile gloves should be worn.
For eye protection chemical goggles should be worn. 
Wear protective clothing when handling.

Storage and transport:
Maximum Storage temp: 120 degrees Fahrenheit
Minimum Storage temp:  35 degrees Fahrenheit

Store at moderate temperatures.

Keep from freezing. If product freezes allow it to slowly warm to room temperature and stir thoroughly before using.
Always store material in its original container.
Keep container tightly closed when not in use.  .

Other Precautions:
Keep out of reach of children.
Read the entire label before using the product.

Follow the label directions